I have LPC1227 board and can't program it with your OpenOCD debugger.

FTDI provide drivers and instructions at their web site, download them and use our ARM-USB-OCD PID: 0x0003, VID: 0x15BA to install the drivers.

It has FTDI drivers, how should I alter them to work with my installation? I am currently using operating system X.IAR EW has support for GDB and works with ARM-USB-OCD.Dimensions 50x40mm ~ (2x1.6)' + 20cm ~ 8' JTAG cable - ribbon cable included.Works with IAR EW for ARM via GDB server.Downloadable Windows installer for full featured and open source tools as alternative to the commercial ARM development packages: GCC C compiler, OpenOCD debugger and Eclipse IDE.Supported by the open-source community and OpenOCD debugger software.Supports ARM targets working in voltage range 2.0 – 5.0 V DC.

Uses ARM's standard JTAG connector (2 rows × 10 pins at 0.1'' step).Can be used to power your target board with three jumper-selectable power supplies: 5V, 9V and 12VDC USB source current is limited with resetable fuse at 300mA, at the different output voltages the maximum current is different: 5V/200mA, 9V/100mA, 12V/70mA, note that this also depends on your USB host current capabilities, if other USB devices are attached to your computer or if the laptop is running on batteries these figures may be different and would depend on your computer USB host. Cable for the external powering included - 2.1x5.5x14mm female connectors at both ends.Debugs all ARM microcontrollers with JTAG interface supported by OpenOCD.Adds virtual RS232 port to your computer with all modem signals like: DTR, DSR, DCD, RTS, CTS, Rx, Tx.First on market three-in-one USB JTAG debugger - offers JTAG + RS232 (full modem signals supported) port + power supply all in one compact device.

Crossworks 1.7 keygen